Scientific Atlanta DVR Guía de instalación descargar pdf (Pagina 7)

Using My DVR Expander with Scientific Atlanta DVRs | 6

Using My DVR Expander with Scientific Atlanta DVRs

Connecting the DVR Expander to a DVR

1. Check the recording space on your digital video recorder (DVR). Write down the percentage of used and

available space, then power off the DVR and disconnect its power cord.

2. Connect the AC adapter cord to the DVR Expander and electrical outlet as shown below. The power LED

illuminates.

3. Connect the eSATA cable to the DVR Expander and DVR.

4. Power on the DVR.

5. Check the recording space on your DVR. If the DVR Expander was detected properly by the DVR, the

percentage of used space should be decreased and the percentage of available space should be increased.

If the DVR Expander was not detected properly, disconnect the drive as described in “Disconnecting the

DVR Expander” in the next section then repeat the steps above.

†

For more information on the Kensington Security Slot, visit www.kensington.com.

CAUTION: Do not connect to the auxiliary power connector on the back of the DVR, as it is not an

adequate power source for external drives.

Front

Rear

Power LED

eSATA Connector

Power Supply

Connector

Kensington

Security Slot

†

Step 3 eSATA Connection to DVR

Step 2

Power Connection

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

Scientific Atlanta DVR Guía de instalación Pagina 7